generative modeling for Rhino
The initial definition attached shows the growth of the structure using Grasshoper and Hoopsnake by controlling the angels of rotation.
I managed :) but it is not on your definition (please see attached and below).
It should be the same logic for you: The "current" triangle rotate using as rotation axis the closest edge to the guide curve. When the t-value of the closest point to the curve from the edge is more than 0 then the t-value goes up by a certain amount and the closest edge used as rotation axis follows this new point...Have a look at the def, I am sure it will make more sense.
You might need to change the increment of the t-value on the curve otherwise it can stay stuck.
Hope this helps,
Thanks a lot. I will have a look at it and let you know for any questions on the definition.
Just a quick question. I figure out that the way the definition you provided works with the mid point of the edges of the triangles to the closest point on the given curve. An the next triangle mirrors on the edge of the previous one right?
If I apply the definition to my component though it doesnt work as the three points will be located on on line. Any suggestions how I can apply?