Grasshopper3d Geodesic Dome Structure Generator (GGDSG) Geometry Gym 02.05.12

Replies to This Discussion

Permalink Reply by Paul Goodship on May 2, 2012 at 4:37am

Please could someone let me know, is there a way to lay out flat in 2D all the bits from the Bake?

 

update: 2 x the definition and disconnect the scaling bit.

Attachments:

• 02 Grasshopper3d Geodesic Dome Structure Generator (GGDSG) Geometry Gym 02.05.12.gh, 10 KB

Permalink Reply by Paul Goodship on May 2, 2012 at 6:19am

update: second dome rotate slider

 

 

Attachments:

• 03 Grasshopper3d Geodesic Dome Structure Generator (GGDSG) Geometry Gym 02.05.12.gh, 10 KB
• Geo Dome Bake Bits1.3dm, 1 MB

Permalink Reply by Paul Goodship on May 2, 2012 at 5:20pm

Please can someone help?  I have been trying to follow this “orient objects onto surfaces by digitaltoolbox.info” tutorial http://youtu.be/kNfjFYukljk and apply it to my geodesic dome structure generator with limited success. If anyone could help me laid out flat the pieces that would be grate?

Attachments:

• 05 SHEET LAYOUT+ Geodesic Dome Structure Generator (GDSG) 03.05.12.gh, 22 KB
• 05 SHEET LAYOUT+ Geodesic Dome Structure Generator (GDSG) 03.05.12.3dm, 169 KB

Permalink Reply by Paul Goodship on May 3, 2012 at 7:44pm

Tidied up my definition a bit and noticed there is a difference if you’re starting point is 0,0,0 if you move the point out from 0,0,0 is works better and you don’t get added lines on the top polygon. Half the dome still looks a mess but you can extract the good half from the back. Was wondering if it is possible to just have the good bits all round instead of half the dome?

I have switched the prevue off on the bit that is supposed to lay out flat all the surfaces as this is work in progress and looks a mess to start with.

Attachments:

• 11 Grasshopper3d Geodesic Dome Structure Generator (GGDSG) Geometry Gym 03.05.12.gh, 22 KB