generative modeling for Rhino
I set up a definition to do the thermal analysis using Viper in DIVA. There is no error but the output is Null. Does anyone know where is the problem?
P.S. I tried both Rhino 4 and 5, there is no change!
The file works on my end. Are there any messages in Viper's 'messages' output? What version of the Grasshopper assembly are you using?
Here is the Viper's messages output:
No windows were included, If this was not intended, make sure window breps intesect zone breps and are coplanar with them.
IDF file written:
E+batch file written: C:\DIVA\EnergyPlusV7-0-0\DIVA_for_Grasshopper.bat
Weather file: USA_MA_Boston-Logan.Intl.AP.725090_TMY3
Attemptingn to run batch file...
Batch file launched successfully.
There is no error here. And I am using Grasshopper 0.8.0066 and Rhino 4
Thanks for any help
any comments? !
Sorry for the delay, Nick. Does anything happen when you set Run to True? i.e., Does the black EnergyPlus window not appear at all? Or does it merely flash and then immediately close?
yes, it flashes and immediately close (in a second), and the outputs are null without any error!
Any suggestions?! I have the same problem!! :-(
Hope that someone could help us.