generative modeling for Rhino
Hi I am trying to run a simulation for a grasshopper definition of a screen (panel with circle holes). The quick visualization show that it is not the same model. Can anyone have an idea how to fix this.
when I bake it it different.
I think the difference you see might be the result of the very low resolution settings for the quick visualization. The quick visualization was intended meant to just confirm that the geometry exists, but small apertures may be missed by the raytrace at those settings. Try running a visualization with the rhino toolbar at medium settings, then run it with the grasshopper component on the grasshopper geometry, it should look closer to the actual geometry.
Thank you, I did a medium visualization and it worked.