Grasshopper

generative modeling for Rhino

Waiting for Revit to connect...?

Hi Hiroshi,

Thanks a lot for the plugin! With the "Revit Adaptive Component Example" file, I am getting the following message on Grasshopper:  "Waiting for Revit to connect...Please activate the Place Adaptive Components command in Revit"

My Revit is turned on and I have clicked on "Place Adaptive Component" as you can see on the image below.

What am I doing wrong?

Many thanks,

Arthur

Tags: adaptive, chameleon, component, plugin, revit

Views: 120

Replies to This Discussion

Permalink Reply by first1 on October 25, 2012 at 6:21pm

Hi Arthur,First you need to  load the adaptive family to project!

Permalink Reply by Arthur Mamou-Mani on October 25, 2012 at 6:24pm

Thanks first1, I read this too and tried my best but the message on GH did not disapear.

Permalink Reply by Azim on December 18, 2012 at 11:05am

Hi Arthur! Did you figure out the problem? Because I've got it also :(, if you did, could you share with solution plssss.

Thank you in advance! 

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service