What's the version of .net should the component be in Grasshopper 0.8.0013?

Replies to This Discussion

Permalink Reply by Danny Boyes on July 12, 2011 at 7:11am

I don't think the change over will come before Rhino 5 switch over. See here: http://www.grasshopper3d.com/forum/topics/a-good-way-to-debug?comme...

• ▶ Reply

Permalink Reply by David Rutten on July 12, 2011 at 7:15am

When Grasshopper runs in Rhino4, it will either use .NET 2·0 or .NET 3·5 (or anything in between, depends on what's available on the system). If Grasshopper runs in Rhino5 it uses .NET 4·0. Grasshopper itself is compiled against .NET 3·5.

 

I recommend you use Rhino4, .NET 3·5 and VS 2008 as a debugging platform.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ▶ Reply

Permalink Reply by Jerome on July 13, 2011 at 3:32am

Thanks, David!

• ▶ Reply

Permalink Reply by Stan Vinokur on July 12, 2011 at 8:05am

Hi David,

 

Quick question, the latest version of GH runs on Rhino 4 - correct? My offices IT thinks its only for Rhino 5.

 

Thanks as always!  

 

Stan

• ▶ Reply

Permalink Reply by David Rutten on July 12, 2011 at 8:32am

It will run on both. Though sometimes there's a brief period between a Rhino5 and a Grasshopper release where they are 'out of synch'.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ▶ Reply