Grasshopper

algorithmic modeling for Rhino

Welding adjacent polylines

Hi,

Is it possible to "weld" several adjacent polylines, but keep them as separate objects?

In order not to have this small gap. In the rhino file the distance is even small less than 0.01% of a unit.

Views: 710

Attachments:

Replies to This Discussion

Permalink Reply by Andrew Heumann on August 24, 2016 at 12:09pm

Try this - the approach is to use "Cull Duplicate Points" on all the vertices of all polylines, and then match the original polyline vertices back to the reduced set. 

Attachments:
Permalink Reply by Tomas Vinkevicius on August 24, 2016 at 1:24pm

Thank you very much:)

By the way do you know why this happens? And is it the same in scripting?

Permalink Reply by Andrew Heumann on August 24, 2016 at 4:33pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service