generative modeling for Rhino
in your case the Offset goes to the outside of the cells.
But I think you want to have it in the inside.
For this just input a negative number in D.
There are many solutions to do this.
Right click on the D input of the Offset Component and go to expression and write there -D, then the Slider value get's the opposite value
or take the Negative Component from the Math tab to negate the slider value
or just edit the slider from a negative number to 0 or -1 or something else, this depends on you.
Hope this helps.
genius! thank you very much for the help!
try 1000 things and could not do it!
I appreciate your help