tubes on voronoi

Replies to This Discussion

Permalink Reply by Francisco Lara on December 3, 2009 at 4:46pm

try baking the lines and then look for a script called hyperpipe try if that helps

• ▶ Reply

Permalink Reply by Dahu Mumagi on December 3, 2009 at 7:11pm

thanks Francisco, but cannot see this script,

• ▶ Reply

Permalink Reply by Manuel on December 3, 2009 at 8:57pm

There is some kind of problem with the project curves....
The explode component was not working properly, so I use the shatter component, then I orient a circle on every curve and finally I use sweep one rail.

Attachments:

• voronioforproj[autosave].gh, 46 KB

• ▶ Reply

Permalink Reply by Dahu Mumagi on December 3, 2009 at 9:24pm

thanks a million!

• ▶ Reply