Grasshopper

algorithmic modeling for Rhino

Timers

Hey everybody..

 

This is a very simple question; how do you disconnect a timer from a component ?

 

I know that this is not a very usefull thing, but I have found my self getting annoyed about this factor. So does anyone know if this is possible? or is it something that will be added over time? since its not an imediate issue.

 

- Jens

Views: 227

Replies to This Discussion

Permalink Reply by David Rutten on August 20, 2011 at 4:02pm

Same way you remove other wires. Redraw the connection while holding Control.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Jens Pedersen on August 20, 2011 at 4:04pm
Excellent.. thank you!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service