Grasshopper

generative modeling for Rhino

surface (which was made by loft) is not divided by any surface's tool...

"Hello! Is there any way to divide a surface which it was made by loft? No command of surface works on loft :("

Views: 203

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Michael Pryor on July 4, 2012 at 3:40pm

because your surface has a facet.

Permalink Reply by Doğukan Çıldır on July 4, 2012 at 3:46pm

sorry... What does it mean facet? and Can't I divide it in this situation?

Permalink Reply by Michael Pryor on July 4, 2012 at 4:18pm

http://en.wikipedia.org/wiki/Facet

try the contour components

Permalink Reply by Jissi Choi on July 4, 2012 at 11:38pm

Hi.. You need to make a surface untrimmed.. to use surface components on it..

 

The surface you made was a polysurface of four surfaces..

 

It is because you used arc and polylines to loft..

 

I attached an untrimmed surface.. I wish It might be helpful..

Attachments:
Permalink Reply by Gongming Liu on July 5, 2012 at 1:39pm

You could also try to rebuild all your polyline curve into planer curve as my pic shows, then, loft it.

Permalink Reply by Doğukan Çıldır on July 5, 2012 at 2:27pm

Thank you guys for your help. I've divided it :)

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service