algorithmic modeling for Rhino
Hi
I run an easy test with two planar surface. The one with the hole shows an offset of the domain if I use the approximate surface dimensions, otherwise it's correct with the reparametrize surface. The offset seems to start from the circle starting point.
There's some hidden logic or something else?
Thanks
Paolo
Tags:
I think you're making a faulty assumption that the surface domain is tied to the surface dimensions. This is sometimes but not always the case. You're always better off using a reparameterized surface - or you can get the surface's actual domain by passing the surface through a "2d domain" parameter to see what it actually is.
Welcome to
Grasshopper
Added by morteza khorsand 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by