srf split

Replies to This Discussion

Permalink Reply by Systemiq on May 15, 2011 at 9:34am

The loft gives a Brep as result, split surface cant work on that.

You can probably work on the faces of the brep.

• ▶ Reply

Permalink Reply by veronica arcos on May 15, 2011 at 11:52am

thx a lot!

• ▶ Reply

Permalink Reply by Systemiq on May 15, 2011 at 1:23pm

Oh, and if you need the dispatch working to separate correctly the splitted fragments, you can try something like this:

• ▶ Reply

Permalink Reply by RWNB on May 15, 2011 at 2:03pm

dear systemiq,

what a value give you in the vec (vector) component?

thx.

• ▶ Reply

Permalink Reply by Systemiq on May 15, 2011 at 2:16pm

It was z by default. I added a vector to be sure that if you project the curve in another direction, the extrude will take the same direction.

The extrude is there to catch the surfaces splitted 'inside' the curve.

• ▶ Reply

Permalink Reply by Danny Boyes on May 15, 2011 at 9:37am

SrfSplit only works on surfaces. What you are supplying is an Open BRep ie a polysrf.

 

Use the BRep Components component to get the exploded Faces of the BRep to supply the SrfSplit

• ▶ Reply

Permalink Reply by veronica arcos on May 15, 2011 at 11:53am

thank u Danny, it works..

• ▶ Reply

Permalink Reply by RWNB on May 15, 2011 at 9:50am

(:

Attachments:

• TELA_01.ghx, 244 KB

• ▶ Reply

Permalink Reply by veronica arcos on May 15, 2011 at 11:53am

thank u!!!

• ▶ Reply