Split points from several lists and make a curves???

Hi,

I divide 3 line into 60 (or random) points.

Now i have to make curves between these points (between divided lines).

But i dont now how to split lists or to collect same points so i can join them.

Like, first points in lists are first curve, second points in lists are second curve, and so on.

List1-List2-List3

1-1-1 first line

2-2-2 second line

3-3-3 third line

4-4-4 ...

5-5-5...

and so on..

Thanks!!!!!!!!!!!!!!!

▶ Reply to This

Replies to This Discussion

Permalink Reply by Dana Zammit on May 1, 2012 at 10:05am

what do you think i should flip? sorry im quite new to gh and have never used this command before

▶ Reply

Permalink Reply by Dana Zammit on May 1, 2012 at 11:04am

Hi Milan

This is what i got when i set periodic curve to true. it turned the curves into closed loops

▶ Reply

Permalink Reply by Danny Boyes on February 16, 2012 at 2:01pm

HI Milan,

You can also use the Flip Matrix Component found on the Sets Tab > Tree Panel which will change rows to columns and columns to rows of a single separation Data Tree

▶ Reply

Permalink Reply by MilanK on February 16, 2012 at 3:04pm

Tnx Danny,
I try your way too, also good
and simpler

▶ Reply

Permalink Reply by Dana Zammit on May 1, 2012 at 11:13am

this is what B says:

▶ Reply

Permalink Reply by Danny Boyes on May 1, 2012 at 11:21am

that's them. they are not connected to the intcrv component so they will not be used for any curves

▶ Reply

Permalink Reply by Dana Zammit on May 1, 2012 at 11:44am

worked!!

last question, promise! :)

why can't i loft these curves? i tried but it lofted the 0-0-0 curve and 11-11-11

▶ Reply

Permalink Reply by Danny Boyes on May 1, 2012 at 11:49am

because they are on separate branches. either flatten the input to theloft component or use the shift branches component with a value of -1 to get all the data on one branch

▶ Reply

Permalink Reply by Dana Zammit on May 1, 2012 at 11:58am

did it!!! thanks a million i really appreciate your help!! :D

▶ Reply

Permalink Reply by Danny Boyes on May 1, 2012 at 12:08pm

why did you need the split list component? i suggest you remove them and just have that wire going into a single entwine component. no need to double up on them

▶ Reply

Permalink Reply by Dana Zammit on May 1, 2012 at 12:27pm

i managed...i have quite a few extra things since i wasn't exactly sure what i had to do! will go through it and see what i can erase to clean it up :)