generative modeling for Rhino
I divide 3 line into 60 (or random) points.
Now i have to make curves between these points (between divided lines).
But i dont now how to split lists or to collect same points so i can join them.
Like, first points in lists are first curve, second points in lists are second curve, and so on.
1-1-1 first line
2-2-2 second line
3-3-3 third line
and so on..
what do you think i should flip? sorry im quite new to gh and have never used this command before
You can also use the Flip Matrix Component found on the Sets Tab > Tree Panel which will change rows to columns and columns to rows of a single separation Data Tree
that's them. they are not connected to the intcrv component so they will not be used for any curves
because they are on separate branches. either flatten the input to theloft component or use the shift branches component with a value of -1 to get all the data on one branch
why did you need the split list component? i suggest you remove them and just have that wire going into a single entwine component. no need to double up on them
i managed...i have quite a few extra things since i wasn't exactly sure what i had to do! will go through it and see what i can erase to clean it up :)