Grasshopper

algorithmic modeling for Rhino

Solid creation

Hi

I have created 3D curve and tried to extrude a circle along it  (use it as a sweep1 rail).
The curve is composed of two pieces (1st order continuity) and I'm unable to convert the sweep in solid.

I tried also pipe but besides the above I observe the strange overlapping "shapes" around junction, and first points of the curve.

Thanks for any indication!

Views: 290

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on June 26, 2016 at 9:46am

Hi.

Your two different point sets have their own data tree structure so, they won't be merged properly.

Check the red groups. Best.

 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service