Grasshopper

algorithmic modeling for Rhino

Slice a Brep into sections to prepare for CNC milling.

Hi, I'm trying to slice an elliptical solid into sections, so I can prepare them to cut out of MDF board (12mm thickness).

The main part that's bothering me, is the Brep|Plane that creates more sections than the number of perpendicular frames. I've read that this seems to be 'by design' so I was wondering if someone would have another approach to tackle this problem, please?

Kindest regards...

Views: 2910

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on September 23, 2015 at 10:30am

Looks nice!

What material is it made of?

Permalink Reply by Luc Bossuyt on September 23, 2015 at 11:58am

Simple plywood (bendable), lots of polyester filler, even more manual sanding and a nice glossy finish. This is the prototype. I'm now in the process of making a rubber mold so I can reproduce it in concrete. (to be continued...)

Permalink Reply by Daniel Kelso on February 10, 2016 at 6:09pm

Awesome Process!

Permalink Reply by Luc Bossuyt on February 11, 2016 at 3:18am

Thanks! The making of the mold failed over and over again. I had to hand it over to a pro. Almost ready to reproduce...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service