Grasshopper

algorithmic modeling for Rhino

Hello, I'm trying to get this hex grid to trim so that only the offset lines show up. not the intersecting ones. Please see attached photo!

Views: 1203

Attachments:

Replies to This Discussion

  1. disable 'Preview' for the 'HexGrid' component
  2. use a negative value for the 'Offset D (Distance)'; you can add the expression "-x" to the 'D' input

P.S.  You might want to try replacing standard GH 'Offset' with the Clipper plugin ('PolyOffset'), as recommended by David Rutten, June 9, 2017:

for GH1 I recommend using the Clipper plugin, I'm planning on adding the clipper code directly to GH2 so it is accessible natively.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service