Grasshopper

generative modeling for Rhino

Section a surface?

I have loft a surface from 3 parabola curves,

Now I need to find 20 sections on the surface.

Anyone can help?

Following image shows what I want from the surface.

GH file is attached.

Thanks!

Views: 120

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by fernando molas garcia on May 11, 2012 at 8:34am

this is what you looking for?

Attachments:
Permalink Reply by Oskar Lue on May 11, 2012 at 9:06am

Thanks a lot! That's exactly what I want.

I have a further question, if u can help:

How to trim the curves with a horizontal surface?

eg. All the start pt and the end pt of the curves are on a same level (xy plane).

Thanks again!

Permalink Reply by Michael Pryor on May 11, 2012 at 8:36am

look at intersection tab, as well as contour components

Permalink Reply by Oskar Lue on May 11, 2012 at 9:07am

Thx!

Permalink Reply by fernando molas garcia on May 11, 2012 at 9:53am

an idea

Attachments:
Permalink Reply by Oskar Lue on May 11, 2012 at 4:58pm

Thank you so much Fernando!!!

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service