Grasshopper

algorithmic modeling for Rhino

Hi, I have a difficult to create this Roof, with a strange curved form, but the difficult for me is inclinate the roof and in someway have the wall that follow the roof, became all one with that, i think it's easy, but i don't how can i do that 

Thank you in advance :)

Views: 1119

Attachments:

Replies to This Discussion

nobody know it ? :(

is that what you'r looking for?

Attachments:

Yess perfect, but in my project doesn't work, it say: 1. Planar surface routine returned no results (in the "boundary Surface") :(

You need to make the domain of the x and y of your plane that your projecting onto equal to or large than the size of the curve your projecting (Currently its missing in places). Also check the curve your projecting is closed. This should then solve the issue with the boundary surface not being created.

Thanks a lot! now it work!! :) I think if i use the same concept for the single wall, and repeat that with the same value, i think it would work! :D

I was wondering what is the interest of creating a house 3D model in grasshopper? 

it's a project for University, but i find many difficult with revit becouse of its all spline, so i try to use Rhino+Grasshopper and i'm learning much things! 

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service