Revolve Surface

Replies to This Discussion

Permalink Reply by Systemiq on April 23, 2011 at 7:30pm

Without the curve input, and the axe on RevSrf, I am afraid no one knows how to fix it.

• ▶ Reply

Permalink Reply by Chris Tietjen on April 24, 2011 at 4:52pm

Chris

• ▶ Reply

Permalink Reply by Chris Tietjen on April 24, 2011 at 5:22pm

Graft the input to the Revolve component if you have multiple input curves.

Chris

• ▶ Reply

Permalink Reply by Danny Boyes on April 24, 2011 at 5:01pm

Hi Martin,

The fact that you have am open BRep after the Revolve would suggest that your curve input is not a single curve and is therefore making a polysurface.

• ▶ Reply

Permalink Reply by Martin Hodge on April 24, 2011 at 5:40pm

Thank you Chris and Danny,

This is a great help. I was trying to revolve a catenary and it did revolve as a number of polysurfaces.

 

Martin

• ▶ Reply