Grasshopper

algorithmic modeling for Rhino

Replacing "OnX_Event" to "IntesectionEvent"

Hi, i'm updating a VB.NET Component Because the original code were in a old GH version.

I searched in RhinoCommon develope and found "IntersectionEvent"

I replaced:

"Dim hit As New OnX_Event" by "Dim hit As New IntersectionEvent"

But The software Said that the type it not definite

What is wrong?

Views: 297

Replies to This Discussion

Permalink Reply by peter fotiadis on August 28, 2016 at 2:21am

Post the dinosaur.

Other that that ... see this (Curve/Plane) for example:

Permalink Reply by peter fotiadis on August 28, 2016 at 2:53am

BTW: Get this as well (rather entry point training material for my people in my practice): has more intersections than Sahara has grains of sand.

Attachments:
Permalink Reply by Julian David Ortiz Mojica on August 30, 2016 at 9:09pm

Thanks Peter.

Permalink Reply by Daniel González Abalde on August 28, 2016 at 2:56am

Si un tipo no está definido quiere decir que ningún espacio de nombres importado encuentra ese tipo. 

Si estás desde VS podrías importar Rhino.Geometry.Intersect, sino tienes que acceder al espacio de nombres y seleccionar el tipo:

 Dim hit As New intersect.IntersectionEvent.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service