Grasshopper

algorithmic modeling for Rhino

Relatively Complex Geomtry

Hello,

I am new using grasshopper and I have a geometry question. I would like merge two geometries together (a square and a circle) and make them so they use a mesh (which is deformed to fit each on different sides) as a tube. Does anyone have any idea of how to achieve this? There is a similar tool in Revit that allows you to define a distinct base and top geometry before completing the extrusion.

Thank you! 

Views: 247

Replies to This Discussion

Permalink Reply by Mkr on April 2, 2015 at 5:29am

Loft, Sweep, Ruled surface can do it.

Permalink Reply by Riccardo Majewski on April 2, 2015 at 5:51am

OR, if you are mindless like me, build everything manually! :D

Attachments:
Permalink Reply by Mkr on April 2, 2015 at 6:18am

Or mindless like me and using graphs everywhere. 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service