Grasshopper

algorithmic modeling for Rhino

Reduce Pixelation

Hello. I'm working on a form which I would like to manipulate, but am having a hard time. I was able to pixelate an original geometry into 10'x10' cubes, but I was wondering if there is a way to have them reduced randomly as you get higher in the z direction. In essence, I want the first row or two to be solid with the cubes getting progressively less frequent as you go up higher in the geometry. Any ideas how to do this?

Thanks in advance!

Views: 451

Attachments:

Replies to This Discussion

Permalink Reply by Vongsawat Wongkijjalerd on March 8, 2017 at 1:27am

bit late but
replaced ArrLinear with Move+Series, so that each branch is a z grouping. 
Then after BrepInc, each group is percentage culled linearly.

Alternatively you could RandomReduce prior to BrepInc if you prefer as well

Attachments:
Permalink Reply by Ben on March 8, 2017 at 5:47pm

Thanks, I haven't tried this yet but the logic seems spot on!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service