redo operation on list

Hi Folks

I am fairly new to Grasshopper and hope someone can help me with this potentially simple thing.

I am trying to use a number of divided rhino generated cross section curves to construct a number of curves connecting the division points of the cross section curves.

I can manage to create one curve from my list of lists of points but I can not figure how to do them all in one go.

I attach two images - one from rhino showing my single constructed curve between my cross section curves and one Grasshopper image showing my sketch so far - somehow the red marked slider should increment or some operator should recall the last curve operation.

I hope someone can help!

Best regards - andreas

Tags: list

Attachments:

01_rhino_curves.jpg, 455 KB
02_grasshopper.jpg, 471 KB

▶ Reply to This

Replies to This Discussion

Permalink Reply by Thomas Roncco on June 2, 2012 at 6:48pm

Hey Andreas,

It would be helpful if you attach your gH and Rhino file. I will be happy to try and help if I can experiment with the file.

▶ Reply

Permalink Reply by andreas lykke-olesen on June 3, 2012 at 12:10am

Hi Thomas

That would be super if you could take a look. I can see that looping and recursive stuff might be harder in grasshopper but still I would think that what I am trying to achieve would be simple. I have looked at Hoopsnake but I am not sure that it can help me...

There might be many smarter ways to do it?! :)

Here you have my Rhino and Grasshopper file.

Best regards - andreas

Attachments: