generative modeling for Rhino
Any ideas on how to find out the index number of the curve a point has been pulled to when using the Pull Command. As if i use Crv Closest point it duplicates all the data.
Great idea though i need to match a list is of points to a list of curves which this code does not seem to like to do. Only have about 12 Curves but code is creating sub division system so points end up in the 1000's. So the closest point component logic i was using gets very slow.
Just trying to find out if Pull is scriptable so i can get the index with little luck.
you can tell me what is te name of component that looks like a red circle?
This is old, but well... could be helpful (for historical reference?).