Project curve on Brep issue

Replies to This Discussion

Permalink Reply by David Rutten on November 4, 2011 at 7:57am

Hi Bojan,

 

can you post the geometry I need to replicate this?

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ▶ Reply

Permalink Reply by Bojan Keneski on November 7, 2011 at 12:58am

Hi David,

here is geometry.

Looking forward for your answer.

Attachments:

• Project curve on Brep issue.3dm, 45 KB
• project curve on Brep issue.gh, 2 KB

• ▶ Reply

Permalink Reply by Pieter Segeren on November 7, 2011 at 3:28am

Hi Bojan, I don't think that's the proper way to use the revolve. I would use only half of the profile curve and revolve that 360 degrees (2*pi). Than the projection works fine.

• ▶ Reply

Permalink Reply by Bojan Keneski on November 7, 2011 at 4:11am

Hi Pieter,

I have noticed that projection works fine with surfaces made with half profile curves. I am wondering, it should be the same result if full profile curve is revolved for 180 degrees? (like in Rhino). I just want to understand logic why it can't be done.

• ▶ Reply

Permalink Reply by Pieter Segeren on November 7, 2011 at 6:04am

Ehm, I always use a single profile curve when revolving, I mean one that is not crossing (touching is allowed) the revolve axis.
I don't think it is good practice to use the whole curve Bojan, but I can't explain very well why this is.

• ▶ Reply