algorithmic modeling for Rhino
Hi all,
I am having problems isolating a particular area within a colour mesh. If I try to select an area from the left edge of the mesh, there is no issue. If I attempt to select an area from within the mesh, it does not recreate the selected mesh area.
Selected area of colour mesh from left edge
Selected area from within colour mesh not properly displayed\
I have attached the above grasshopper definition for everyone’s reference. It’s a modification of a definition describe in this post:
http://www.grasshopper3d.com/forum/topics/covering-a-surface-with-a...
With reference to the attached definition, if I were to change both values highlighted in the definition to zero, the selected zone at the edge appears but not with the values used in the definition for selecting an area within the mesh.
Hope someone could help me on this.
I am currently using grasshopper version 0.8.0066.
Thanks and best regards
Siong
Tags:
Welcome to
Grasshopper
Added by morteza khorsand 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by