Grasshopper

algorithmic modeling for Rhino

Hello. I have a problem making an offset curve in both directions. I have two offsets connected to the same slider, but in one of the offsets introduce the expression "D" to do the offset in the opposite direction but with the same magnitude. The problem is that grasshopper does not recognize that term, and I have seen it on video function. which may be the problem?

Views: 263

Attachments:

Replies to This Discussion

Your expression modifier is likely bad, and should look like this, with -x:

The format of expression modifiers may have changed since the video you learned from:

http://www.grasshopper3d.com/forum/topics/what-are-the-icons-on-a-c...

Or you could just multiply by -1 instead, using the Multiplication component.

Thank you very much.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service