PROBLEM making a planar surface/loft in curves

Hi, i hope someone can help me! I made a Voronoi and mapped it to a surface! But now i want to make a surface through the resulting curves.. but I can't! Can someone help me??

Tags: Voronoi, curves, loft, planarsurface, surface, surfacemapper

Attachments:

circulacionpiel.ghx, 1.3 MB

▶ Reply to This

Replies to This Discussion

Permalink Reply by Karen Cerda on April 13, 2011 at 5:37pm

Attachments:

pielcv.3dm, 81 KB

▶ Reply

Permalink Reply by Dedackelzucht on April 14, 2011 at 12:52am

I was wondering, if your offset is in the right direction?

And which curves do you want to use for which surface? :-)

Best Regards

DaDackel

▶ Reply

Permalink Reply by Karen Cerda on April 14, 2011 at 11:55am

I'm trying to have this approach but with the other volume.. =) But i tried to do it with planar surface and loft and none of them worked! :(

Attachments:

loft.bmp, 2.7 MB

▶ Reply

Permalink Reply by Beltrán Fernández Mariño on April 15, 2011 at 8:21am

▶ Reply

Permalink Reply by Beltrán Fernández Mariño on April 18, 2011 at 4:20pm

Hi Karen,

Maybe I misunderstood what you need. Do you want to "map" some Voronoi cells to a surface and then you want to get outside these cells surface/s (that's what I understood you tried by planar/loft)? Am I right? Was the previous post useful?