Performance tweaks for Voronoi pattern panels

Hi

I have been working away with tips from these discussions for a few weeks.

I am at the point that other than minor tweaks I have the program doing what I need it to do, I am creating a Voronoi pattern on a plane to be cut out of aluminium using a laser cutter.

The issue I have is that to create what I need, it has got to the point it takes too long to run if I enable all of the steps, at its heart I am sure that the tool can do what I want much quicker, and my sequencing of steps is the root of my issues.

In the attached file I have disabled the fillet and region and boundary steps at the end because the file won't open with them enabled with the complexity variables of the model turned up.

Density sets the complexity of the pattern (lower numbers are higher) because each panel is a different size and I need to seed with consistent dot frequency. I need that to probably be slightly lower than 3000

Any help from someone with experience that can point out my likely simple mistake would be highly appreciated.

Thanks

James