Parametrize

Replies to This Discussion

Permalink Reply by Francisco Lara on June 29, 2012 at 11:15pm

• ▶ Reply

Permalink Reply by wrogirzymian on June 30, 2012 at 12:14am

Are those main divisions straight lines or curves? 

Also: Are the wooden plank widths supposed to be random or predefined 3 sizes (like in the pic)?

• ▶ Reply

Permalink Reply by wrogirzymian on June 30, 2012 at 2:36am

OK so the script is very noobish but kinda works

Attachments:

• pattern1.gh, 5 KB

• ▶ Reply

Permalink Reply by RWNB on June 30, 2012 at 4:34am

cool.
can you show us, how to assign surfaces with identical proportions a certain color?

• ▶ Reply

Permalink Reply by wrogirzymian on June 30, 2012 at 5:44am

I was totally improvising and I bet this could be done better but here you go.

Attachments:

• pattern2.gh, 8 KB

• ▶ Reply

Permalink Reply by RWNB on June 30, 2012 at 7:39am

cool!

sorry for a further question.
can you relate your script to a surface?
so that the subdivision refers to the length and the width of the surface,
with the goal that the divisions take place in an enclosed area.

thanks

• ▶ Reply

Permalink Reply by wrogirzymian on June 30, 2012 at 8:01am

I will try tomorrow :>

• ▶ Reply

Permalink Reply by Francisco Lara on June 30, 2012 at 7:40am

Nice! you are great man!

Look:

this is where I am apply the wood planks.

to each one of those triangular faces.

One little detail that you forgot though its the separation between each peace of wood!

how can this be add to the definition! any ideas?

Thanks!

• ▶ Reply

Permalink Reply by wrogirzymian on June 30, 2012 at 8:00am

I am off for today but the  separation is the easy part.

You just take each plank and scale it by it's center point (its in the area component)

• ▶ Reply

Permalink Reply by Francisco Lara on June 30, 2012 at 8:08am

Ja! yeah thats true! :P

hey but RWNB questions sounds Interesting!

any comments on that?

Thanks

you are the man!

• ▶ Reply

Permalink Reply by Francisco Lara on June 30, 2012 at 8:17am

its not that simple!

because the scale affects the elements different because they are different.

any ways a different value has to be apply for each plank.

• ▶ Reply

Permalink Reply by Michael Pryor on June 30, 2012 at 10:43am

wireframe each surface, offset the long sides, re loft the new offset lines.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page