Grasshopper

generative modeling for Rhino

orient multiple geometries

hi all
I'm using the orient component and trying to orient a set of multiple geometries at a series of points. problem is, its orienting single pieces of the (multiple pieces of) geometry rather than complete copies. I'm sure I'm not explaining this well...

in the image under the #3 is the near complete set, then by #1, is just a part of it....

thanks a lot

Views: 57

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Daniel Piker on November 14, 2009 at 4:16pm
Maybe try switching from Longest list to Cross reference ? (when you right click the Orient component)
Permalink Reply by LML on November 14, 2009 at 4:32pm
yeah that did the trick--
thanks!

RSS

Translate

Search Grasshopper

Members

Photos

  • Add Photos
  • View All

© 2012   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service