Grasshopper

algorithmic modeling for Rhino

Move in series error

Hello, 

I am trying to move in series a sym of breps as the attachement 1 (that was a tween between two closed curves). However, when I try the same process for five shattered segments of that same curve, the move in series is not accurate. Perhaps it is a common mistake?

Thank you!

Views: 590

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 21, 2017 at 11:39pm

Take a look at the attachment.

Attachments:
Permalink Reply by F L on September 22, 2017 at 1:43pm

Thank you very much for the answer! I managed to replicate it with another pair of offsets -the empty space in between those steps- however I want the number of steps for the short curve to be twice as much as the long curve, but the inclination of the steps varies (instead of being at the same height)

Attachments:
Permalink Reply by Joseph Oster on September 22, 2017 at 5:25pm

Divide the wider step dimensions by two - and seriously consider a different hobby.

Permalink Reply by Joseph Oster on September 22, 2017 at 6:04pm

You know these steps aren't level, right?

http://www.grasshopper3d.com/forum/topics/how-to-create-stairs

Permalink Reply by Joseph Oster on September 22, 2017 at 7:56pm

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service