algorithmic modeling for Rhino
Hi.
I think it should be pretty easy but I've been trying to connect wires everywhere and none of the options was right. I have used Mesh Split, Mesh Trim and Mesh Difference.
As you can see in the picture below, I have a Voronoi mesh (red) and a solid mesh (green).
I just need the Voronoi mesh that is inside the solid mesh, so just cut off the parts that are outside of the green panel.
Unfortunately I cannot upload the .gh file because it is over 5 MB...
Tags:
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by