Merge Data

When I use the merge tool to combine data streams instead of getting a combined dataset I am getting seperate data sets based on the paths. How do I overcome this problem. Please help .... Find attached the image of the grasshopper file.

Attachments:

image.png, 444 KB

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Rutten on June 11, 2012 at 3:32am

Hi Jyoti,

you'll need to change the data-paths to match up as well. Flattening the inputs of a Merge component will do this, but it may destroy too much information depending on your specific case.

David Rutten

david@mcneel.com

Poprad, Slovakia

▶ Reply

Permalink Reply by JYOTI SHARMA on June 11, 2012 at 3:44am

Hi David,

Thanks a lot for your reply... Flattening did work ...however I was thinking if there is any way to make the path similiar without adding any additional steps to make the paths equal.

▶ Reply

Permalink Reply by Danny Boyes on June 11, 2012 at 3:35am

Unfortunately you chopped of the most interesting part of you image, the actually data path structure displayed in the panel.

It would help a lot if you could upload your definition with any referenced geometry so I can work with the structures as you see them as there are a number of methods to sort this but its not a one size fits all?