Grasshopper

algorithmic modeling for Rhino

I'm trying to set up a script that would output a cubemap of 2D linework using the Make2D component in Rhino 6. It shouldn't be too hard, essentially just defining a camera location and performing 5 different rotations of the camera target and plugging them into Make2D components. Right now, I can only get the Make2D Rhino View component to get the views that I want, which isn't enough unless I can figure out how to automate the creation of 6 named views in Rhino to plug them into GH.

The Make2D perspective view component would be the best way to do it; with inputs just for camera location and frame, I would only have to rotate the rectangular frame about the camera location. But, the component seems to be confused. The output I'm getting is always just a top view of the geometry, no matter where I place the camera or the frame. The description on hover over the output of the component is also suggestion that the output is a Parallel View, not Perspective. Am I using the component wrong?

Views: 673

Replies to This Discussion

I can confirm this component isn't working properly...

Bumping this thread. Andrew, any idea how to get this worked out?

Yup, I'll look into it when I can muster the courage to do so.

Report here.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service