Grasshopper

generative modeling for Rhino

Lofts with points

From what I know, grasshopper does not allow to make a loft beetween a point and a curve. (Rhino does).

Is this option coming in the near future? What alternatives or options do you propose?

Tags: loft, point

Views: 381

▶ Reply to This

Replies to This Discussion

Permalink Reply by Danny Boyes on June 20, 2012 at 4:25am

You could make a very small curve at the location of the Point

Permalink Reply by Edion86 on June 20, 2012 at 7:15am

The good things about using point in a loft is the possibility to make "closed lofts" they end in no-hole. This usually is solved with a revolution curve or similar, but those are more complex situations which i'd prefer to avoid in grasshopper.

Permalink Reply by Systemiq on June 20, 2012 at 10:57am

If the curve is really small, rhino will see no hole.

Try attachment.

Attachments:
Permalink Reply by phillip on June 20, 2012 at 4:41am

Extrude Point

Permalink Reply by Michael Pryor on June 20, 2012 at 7:56am

Permalink Reply by Edion86 on June 20, 2012 at 8:21am

Well, yes. But if you want a doblecurved surface with defined sections by curves in-between.... 

Permalink Reply by Michael Pryor on June 20, 2012 at 8:40am

attach a rhino file. Being vague will not get results :)

Permalink Reply by Edion86 on June 20, 2012 at 9:36am

Here you have a simple example of what I am looking for...

Attachments:
Permalink Reply by Michael Pryor on June 20, 2012 at 10:18am

You can always just add the tip into the lists.

Attachments:
Permalink Reply by Edion86 on June 21, 2012 at 4:01am

Got it. It's a good way. I'll post something when finished.

Thanks  a lot Michael. 

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service