Line needed as perpendicular to plane at centroid point

Replies to This Discussion

Permalink Reply by lucas cañada on December 23, 2011 at 1:25am

maybe there is another solution. Let us know. Hope helps.

Attachments:

• lineneeded.3dm, 53 KB
• lineneeded.gh, 3 KB

• ▶ Reply

Permalink Reply by lucas cañada on December 23, 2011 at 1:55am

if you unitize vector you can get the real length

Attachments:

• lineneeded.gh, 3 KB

• ▶ Reply

Permalink Reply by Naveen on December 23, 2011 at 4:16am

Thanks it worked for me, but seems like i am generating lines in opposite directions too, hereby enclosed, pls help

• ▶ Reply

Permalink Reply by lucas cañada on December 23, 2011 at 4:33am

Post your deff

• ▶ Reply

Permalink Reply by Naveen on December 23, 2011 at 4:38am

Here's how I am trying to crack,pls help

Attachments:

• Getting Lenghts.3dm, 956 KB
• Space Frame.gh, 15 KB

• ▶ Reply

Permalink Reply by lucas cañada on December 23, 2011 at 5:05am

sorry it happens me too. ;(

• ▶ Reply

Permalink Reply by lucas cañada on December 23, 2011 at 5:21am

problem is in referenced curves,how you created before bake, bacause here are only baked lines and some of them are flipped 

• ▶ Reply

Permalink Reply by Naveen on December 23, 2011 at 5:38am

Agreed, Actually I did create uv division (rectangular pattern on surface) and suddenly I was told that the rectangle modulation would be changed to rhombus matrix. So I did draw manually - triangular lines within rectangular patterns. Any best way to break the rectangular pattern into triangles(to form like a rhombus), pls help

Enclosed is the models from which triangles where built

Attachments:

• 1600 Module Model.3dm, 951 KB
• 1600 Module Code.gh, 56 KB

• ▶ Reply

Permalink Reply by lucas cañada on December 28, 2011 at 4:32pm

Hi naveen sorry for delay but _Christmas...

Try this deff. Hope helps. Regards.

Attachments:

• lineneeded_3.3dm, 335 KB
• lineneeded_2.gh, 15 KB

• ▶ Reply

Permalink Reply by Naveen on January 31, 2012 at 9:55pm

Hi Lucas,

Apologies its been a month I am responding to your message, due to christmas and chinese new year holiday's. Thanks for the inputs i'll go through and get back to you,

Cheers!
Naveen

• ▶ Reply

Permalink Reply by Naveen on February 1, 2012 at 10:33pm

Hi,

Thanks for the code, works fine :)

• ▶ Reply