latest version question

Hi, everyone.
How to use imagesampler ?Is there some example before the tutorial publiced?

Replies to This Discussion

Permalink Reply by LuSiD on May 11, 2010 at 8:48pm

I have tried to make a surface using image sampler using two methods - both are in the attached file. In both cases SrfGrid goes red - even when I make the U+1. Any help would be appreciated.

Attachments:

Noam Surface.ghx, 164 KB
Noam Surface.3dm, 29 KB

▶ Reply

Permalink Reply by Mohammed E on October 12, 2009 at 6:32am

hi i have the last version and i cant find the image sampler component why is that :(

▶ Reply

Permalink Reply by Danny Boyes on October 12, 2009 at 7:18am

On the Params Tab in the Special Section

▶ Reply

Permalink Reply by Taylor on October 23, 2009 at 4:59am

Hi guys, when i want to genertate the landform from a picture, how to make there is only one picture in the surface, cause as my points increasing, the there are lots of duplication of the picture will appeare in the surface. Why?

▶ Reply

Permalink Reply by Taylor on October 23, 2009 at 5:59am

I mean, take the beginning example for instance, if i put 400 in the slider, there will be lots of little people form generated in the surface....

▶ Reply

Permalink Reply by P. Casey Mahon on October 23, 2009 at 9:49am

Taylor,

Double clicking the image sampler brings a dialog box where you can adjust the domain values of the image to manipulate the tiling of the image on the surface. Ted Nagi has a good video on the image sampler here.

http://vimeo.com/7005274

good luck

- casey