Grasshopper

generative modeling for Rhino

Inset command in GrassHopper - Baking Geometry Bug



Hi guys,

here you can see my problem creating this command that simulates the "3d studio max inset". When I bake the geometry, that seems to be well done, it creates wrong faces.
Is there a solution? Thank you!

Views: 184

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Carlo Beltracchi on August 4, 2009 at 1:42am
No ideas?
Permalink Reply by Vicente Soler on August 4, 2009 at 5:09am
Can you share the definition so we can take a closer look?
Permalink Reply by Carlo Beltracchi on August 4, 2009 at 7:50am
Off course Vicente!

Thank you!
Attachments:
Permalink Reply by Vicente Soler on August 4, 2009 at 11:20am
It's seems to be a meshing problem. Even grasshopper's mesher is better than rhino's. If you increase the mesh quality the openings will appear again.
Permalink Reply by a-ngine on August 4, 2009 at 12:40pm
I second that. For me it helped just rebuilding the baked srf in rhino with more divPts. Hope that helps.

Regards pat
Permalink Reply by Carlo Beltracchi on August 4, 2009 at 1:17pm
Cool! It works simply rebuilding the baked surface!!!!!!!!

Thank you guys!!!!
Permalink Reply by Vicente Soler on August 4, 2009 at 2:06pm
Since it's a display issue i think it's better just to play with the mesh settings since rebuilding may alter the geometry.

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service