if loop? for loop?

I am trying to turn on my various attractor points at different moments (each is different) with a slider, anyone know how to achieve this?

▶ Reply to This

Replies to This Discussion

Permalink Reply by u on September 30, 2009 at 11:02pm

here is the file

Attachments:

gm_surface5.ghx, 514 KB

▶ Reply

Permalink Reply by Suryansh Chandra on October 1, 2009 at 6:15am

u,

Your posted ghx isn't very useful since it doesn't have the associated Rhino file.

Your problem doesn't sound too complex, you could simply refer all your attractor points into one component (rather than all into different components as you have done now), and then use a list item component with a slider to pass them one at a time to the rest of your definition.

Attachments:

blah.jpg, 65 KB

▶ Reply

Permalink Reply by u on October 1, 2009 at 9:30am

hey sorry about not attaching the file.....i was unsure it was necessary- in any case i have attached it below. I am just a beginner at this. Thanks for the response and I'll try it out.

Attachments: