Grasshopper

generative modeling for Rhino

How to make Space frame?

Hi

I am hoping to form a space frame on a surface that I have drawn on rhino. I'm almost there, it's just that I want to join the mid points that I have moved from each surface division. I've tried to item the set of points to join but no luck... 

I have attached an image of my file, the highlighted points are the ones I moved. Any suggestions on how I could join them to form a grid would be much appreciated. Thank you.

Jisoo

Views: 948

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Sebastian L. on May 9, 2012 at 10:43am

maybe this link helps you:

Digital Toolbox Spaceframe

Permalink Reply by Michael Pryor on May 9, 2012 at 10:44am

interpolate curve the points, then flip matrix the points and interpolate curve the points again.

Permalink Reply by Jisoo on May 9, 2012 at 11:08am

Thank you for the response. Is it possible to connect the interpolate curve onto the move component? I've attached another image. 

Attachments:
Permalink Reply by Michael Pryor on May 9, 2012 at 11:22am

G of move should be in V of interpolate curve (or polyline), then G of move should also be in a FLIPMATRIX (not flip) component, then plug the flip matrix into another interpolate curve.

Permalink Reply by Jisoo on May 9, 2012 at 1:42pm

Thanks for the image. I have just tried the method. It works for the one interpolate curve component but the other is in red... Also could you advise me how I could end the curves rather than in a loop. Thanks again.

Permalink Reply by Michael Pryor on May 9, 2012 at 2:09pm

just post the definition

Permalink Reply by Jisoo on May 9, 2012 at 2:11pm

Thank you

Attachments:
Permalink Reply by Jisoo on May 9, 2012 at 2:13pm

Rhino file

Attachments:
Permalink Reply by Jisoo on May 10, 2012 at 9:12am

Hi Michael

I was just wondering if you had a look at the definition. Your help is much appreciated. Thanks.

Permalink Reply by Chris Hanley on May 10, 2012 at 11:58am

there is a nice tutorial on creating a space frame using paneling tools for GH.  Might be worth a look.

http://www.grasshopper3d.com/group/panelingtools/forum/topics/102-s...

Permalink Reply by lucas cañada on May 10, 2012 at 2:55pm

Is it what you want? ;)

Attachments:
Permalink Reply by Jisoo on May 11, 2012 at 7:58am

WOW! Thank you so much. I was beginning to think it wasn't possible and manually editing! Thanks again :)

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service