Grasshopper

generative modeling for Rhino

How to fit enneper surface into a ellipsoid?

The idea is:

1. revolve curve and make a ellipsoid 

2. create a 5 wing enneper surface 

3. fit it into the ellipsoid so that the ennepers surface outline can slice ellipsoids surface 

4. make multiple floor with Contour  and intersect all this surfaces so when i bake them i can easily delete inside remainings floor surfaces. 

P.s. - In the ghx definition that you'll find attached you'll see an old enneper definition that i used to scale manually, but the problem with it was that it always created approximated intersection that at some parts of ellipsoid surpassed the limit and on the other was just a little bit smaller than the solids contour. 

P.p.s - Why won't it make multiple contours on ellipsoid?

Views: 235

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Igor on June 29, 2012 at 11:22am

Is that you will need?

I hope it will help you...

Attachments:
Permalink Reply by Gogash on June 29, 2012 at 2:46pm

Thank you for your answer! I think i was not very clear so i'll post some of my previous ''experiments' :)


as you can see the wings should be curved and inside not just as contours. 

here is top view

p.s. if you need any other information please ask

Permalink Reply by Igor on June 29, 2012 at 4:31pm

Like this one?.....

Attachments:
Permalink Reply by Igor on June 29, 2012 at 4:39pm

... and try to correct scale....

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service