How to create Projected Curve

Replies to This Discussion

Permalink Reply by to] on July 2, 2010 at 6:33am

functions always report if they were successful or not
so if you want to get the curve it is stored inside the ref variable (byref means it's sending you back the calculated solution)

Dim crvout As OnNurbsCurve = New OnNurbsCurve
crv.GetNurbForm(crvout)
RhUtil.RhinoProjectToPlane(crvout, y)
A = crvout


• ▶ Reply

Permalink Reply by Damien Alomar on July 2, 2010 at 6:43am

Most of the methods in RhUtil don't actually return much more than boolean values, and even at that it can be "tricky" to rely on those boolean values for the success or failure of a given method. What most methods do is output the result of the function into a variable that you have to supply. In this case, the curves that you supply into the method will be changed to the projected curves if the method is successful. You can tell if a given variable does this by looking at the intellisense and seeing if it says anything for [out]

Note that because this particular method changes the input curves, you should really supply a copy of the original curves so that you have the originals lying around.

• ▶ Reply

Permalink Reply by Junichiro Horikawa on July 2, 2010 at 9:03am

Thank you to] and Damien for the help!!
Now I understand what I was missing. I'm glad I asked even though it is totally a newbie's question.

• ▶ Reply

Permalink Reply by Damien Alomar on July 2, 2010 at 11:25am

It takes most people a little bit of time to get used to supply variables that then get filled by a given function. Some times it makes it easier, others its slightly more of a pain, but once you know you can at least deal with it.

• ▶ Reply