How to change the order of selected objects

I'm in trouble because of objects made by grasshopper are out of order.

Normally, the order of baked objects is determined by procedure of grasshopping.

If you know how to change the order in grasshopper or select objects orderly in rhino, can you show me the way?

source

target

▶ Reply to This

Replies to This Discussion

Permalink Reply by Michael Pryor on June 1, 2012 at 9:25am

flip matrix component. Also, I think you should post this in discussion section (just edit the forum location) or re word it so it is answering a question, typically FAQ is posts that are of answers.

▶ Reply

Permalink Reply by Naoki Ando on June 1, 2012 at 8:40pm

Thank you for your help and pointing out my mistake about my post. I was confused because of my first time use of such a forum.

Incidentally, I'm sorry, I think I was misunderstood because I did't make myself clear. I should have explained more thoroughly.

I'm in trouble because the order of items I treat is out of order, so I can't combine each items correctly.

I think your solution, use flip matrix component is able to replace matrix.

But I want to number out of order items like target, not flip matrix.

If it's not too mach trouble, can you show me the way to sort items.

▶ Reply

Permalink Reply by Yasser Hafizs on June 2, 2012 at 2:02am

If you mean sort item, look at FAQ about how to sort in 2d,

cheers

▶ Reply

Permalink Reply by Naoki Ando on June 6, 2012 at 3:50am

Thank you for your reply!

I have looked at FAQ about how to sort in 2d, however I did't get how to use sort list component well because I have just start using grasshopper...

How should I operate in grasshopper and rhino to make the source I attached below like

target.

Does it need something such guide line like FAQ about how to sort in 2d or something else?

source

target

▶ Reply

Permalink Reply by Arco Lee on June 6, 2012 at 6:27am

I hope I am not making the problem overcomplicated.
What I tried to do was to sort the geometry with the coordinates of their center points.
You may rewrite the formula for different order.
In your last post, the formula should be - Y * 100 + X
(100 maybe even bigger,depending of the size of your draw)

Attachments:

p3.gh, 10 KB

▶ Reply

Permalink Reply by Naoki Ando on June 6, 2012 at 8:16am

Thank you very much, and I appreciate it!

I cannot make sure that the order of all items are correct because of the enormousness, but your suggestion is almost solving my problem concerning sort list, so I can advance my work to next step, combine each items.

Thanks!