help me please!

Replies to This Discussion

Permalink Reply by Pieter Segeren on June 14, 2011 at 6:29am

disable the pipes until you're happy with the curves. If you enable the profiler (view>widgets>profiler) you will notice that these pipes are taking a long time to calculate.

• ▶ Reply

Permalink Reply by Danny Boyes on June 14, 2011 at 6:40am

Whilst disabling the Pipe Components would be a good thing to do if your definition really required a lot of processing time you will find that there is a massive difference between your Rhino dimensions and the Space Truss Parameters in the GH definition. Either reduce your rhino model in size or increase your min and max values of the sliders you will see a remarkable difference in performance.

• ▶ Reply

Permalink Reply by Pieter Segeren on June 14, 2011 at 7:06am

Thanks Danny, very good point, which I missed.
(remarkable because I come across quite a lot of geometry around here that has a crazy size compared to the files unit size.)
Good to know this affects the calculation that much, thanks!

• ▶ Reply

Permalink Reply by Nghia on June 15, 2011 at 3:03am

Thank for your helping again Danny Boyes.You're master of grasshopper

• ▶ Reply

Permalink Reply by Danny Boyes on June 15, 2011 at 4:00am

Thanks for the compliment, but I am far from mastering Grasshopper yet. There are many more aspects that I wold like to get better at.

• ▶ Reply

Permalink Reply by RWNB on June 15, 2011 at 4:06am

Please don`t set the bar too high. (:

• ▶ Reply