Grasshopper

generative modeling for Rhino

Help

Hi,

My buildings is made by random and some of them are really small, in ground area. I would like to make a lower limit to my buildings, how do I do that?

Small buildings like the once there have a circle around it. 

Views: 58

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Rutten on March 15, 2012 at 3:07am

Hi anma,

do you want to remove the small buildings or make them bigger?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by anma on March 15, 2012 at 3:09am

I would like to make them bigger. Like give them a lower limit in each direction... and maybe remove some of them.

Permalink Reply by OZ on March 15, 2012 at 3:10am

I think you can just decide how small shall you're smallest unit be, and get a "number" component set to this number. Then, take a "Max" component and connect A to the "Number" and B to the Random engine.

You will only get numbers that are bigger then you're Low limit.

Permalink Reply by anma on March 15, 2012 at 3:26am

Thank you, I will try this

Permalink Reply by Dedackelzucht on March 15, 2012 at 3:24am

Depending on aour input a "remap" is working as well

Best Regards

DeDackel

Permalink Reply by anma on March 15, 2012 at 3:26am

How does the remap work?

Permalink Reply by Dedackelzucht on March 15, 2012 at 3:32am

like this

Attachments:
Permalink Reply by anma on March 15, 2012 at 3:42am

Can I use this remap on a rectangle? 

Permalink Reply by anma on March 15, 2012 at 3:58am

I have tried your ideas, but I don't seem to get it right.

The picture shows how I have created my buildings.

Hope you guys can help :)

Attachments:

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service