Grid spreading 3D

Replies to This Discussion

Permalink Reply by Michael Pryor on August 21, 2012 at 10:45pm

• ▶ Reply

Permalink Reply by Michael Pryor on August 22, 2012 at 6:30am

then you dimt need all this just use a pount attractor on grid points and affect the z direction.

• ▶ Reply

Permalink Reply by Michael Pryor on August 22, 2012 at 8:33am

Just use point attractors (same points that did spreading) on the points outputted from replace, before the poly line component.

• ▶ Reply

Permalink Reply by Michael Pryor on August 23, 2012 at 9:28pm

I strongly suggest you look carefully at definitions, similar to last time, you are missing something. Look at your stream filters G input ;) this is what switches the action. http://2.bp.blogspot.com/-KeKw5ax1pQo/T6c1eQtcj6I/AAAAAAAAAQg/m5TTB...

• ▶ Reply

Permalink Reply by Michael Pryor on August 24, 2012 at 12:27am

Attachments:

• attractor to repulsion switch (non flat list).gh, 10 KB

Permalink Reply by Michael Pryor on August 28, 2012 at 8:25am

seems you haven't set any points or a curve

Permalink Reply by Michael Pryor on August 28, 2012 at 7:29pm

i showed you already how to make varied size circle. Use the same method to move things in z direction.and unfortunately you need a masters degree to teach arch in NY. :)