Grasshopper

generative modeling for Rhino

Grid on Surface

I am pretty new to Grasshopper so I think this should be an easy answer, but I can't figure it out. I have a series of non planar surfaces that I want to place a grid on, but I don't want the points to materialize on the edges. When I use the rectangular grid tool, or the divide surface it puts points on the edges. Any ideas? Thanks.

Views: 715

▶ Reply to This

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 6, 2011 at 2:41am

Hey,

Danny helped me with this here:

http://www.grasshopper3d.com/forum/topics/surfacedivide-points-without

This works for every kind of surface

 

Best Regards

 

DeDackel

Permalink Reply by Aaron Spiering on September 6, 2011 at 8:25am

Great, thanks.

 

Aaron

Permalink Reply by Michael Pryor on September 6, 2011 at 10:44am
That is a great method, the only frustrating thing is it does not work with lists of anything except points. Even if you plug in say geometries set to points it ignores the geometries and still outputs the points.
Permalink Reply by Michael Pryor on September 6, 2011 at 8:52am
check out this border cluster I made. maybe it can help. http://www.grasshopper3d.com/forum/topics/cull-border-cluster

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service